Anyone have any experience with sublingual route of ingesting DPT Hcl? Is it even possible or worthwhile? Would dosage be comparable to an insufflated dose? What would be a good dosing strategy? I really don’t like to insufflate this stuff. Oral route takes too much material. If sublingual isn’t possible I will consider using an MAOI after much more research on how to do this while minimizing any risks. Thanks
sublingual route of ingesting DPT Hcl don't work. You need a maoi for that, 2 grams of SR 40min before you take your DPT oral dose. Smoke it! It works that way with the hcl too. try 20mg first, then increase the dose as necessary To make the smokable base form>>> Take a teaspoon & place desired amount of baking soda (I use ~¼-1\3 vol of DPT to be converted). Put about 2.5ml water in, or about 2\3rds full. Heat gently for ~15 sec over a gas flame...enough to get at least some of the soda into solution...sometimes poking with a toothpick helps. Next the DPT is added...I usually put in 15-50mgs at a time & wait for the reaction to finish. The reaction is finished when the DPT oil has a homogenous surface & C02 generation has ceased. Sometimes a few more seconds over the flame is needed during this time to expedite things. Once you've gotten the desired amount of DPT base & the reaction is complete take an ice cube on the bottom of the spoon for 20-30+seconds. The DPT will become quite viscous & sometimes crystalline looking...the colder the better. If you desire the most pure product take the freezing spoon & dump* the water currently in it out - then place a few drops of cool water on it...swish around...this gets out unreacted soda. Afterward you can blow on the spoon & blast any remaining water out. *If you are a miser you can save the milky solution of soda & atomized base in water in a separate vial...it will precipitate out in a day or two. Usually only a few mgs is lost this way. Otherwise you can take the cold spoon & twirl the thick molasses like DPT up with a screwdriver. Use a fingernail to get the DPT stuck to the spoon out. I usually keep a clean computer heatsink handy & smear it all on the back. Alternately the base can be kept in a syringe in a solution of isopropyl alcohol for easy measured deposition on carrier material. Practice makes perfect but even if you are careless you can still get a great yield in a short amount of time. If done right you can get 98%+ conversion & perhaps only a speck of soda or water in the final product. Best way to smoke the oil base is to get a shot glass, place about 2 drops of the DPT oil into the bottom of the shot glass. Thats about 20 to 30mgs. You can go up to 100mg but thats really mind blowing potent for some. Now add about one or two ml of alcohol into the shot glass, mix it with little a piece of wire you used to drop the dpt with (coat hanger wire works best), it'll mix well. Now put a 1/4 of a joints worth of cannabis, parsley or something smokable in to the shot glass too. The plant material will absorb to DPT very nicely, Now sit back and let the alcohol evaporate and dry. Yes you can use a fan if your in a hurry. After it drys, pack a pipe with it, Hold your lighter just above but don't let the flame touch the plant material. Take a slow big hit and hold it in. Repeat as necessary. Cheers
