Vaporizer problem

Discussion in 'Show Your Piece' started by ZBChrist, Feb 16, 2006.

  1. ZBChrist

    ZBChrist Member

    Messages:
    146
    Likes Received:
    0
    alright, so I tried to use my new vaporizer with less than satisfactory results. I was using the Vapir One system. I tried it with the bags, I tried connecting the rubber tuping and inhaling that way, and eventually I just laid down under the blanket next to the vaporizer and still minimal affects.

    I thought I used plenty of weed, maybe I did not wait long enough? How long does it take for about .1-.2 grams to vaporize? It may be a problem with the actual machine, I did notice that it was leaking from the side a little (where you put the metal herb tray).

    Also, when you vaporize, are you supposed to see the vapor? It seemed like when I was vaporizing, you could see smoke in the very beginning, and after that I had to rely on smell to tell if it was still coming out, is this right? Was I vaporizing at too low of a temperature?

    Someone help me!

    Thanks guys
     
  2. smokindude

    smokindude Senior Member

    Messages:
    3,744
    Likes Received:
    2
    Yes, I believe your heating temp. was not hot enough. Try again and post the results.
    good luck man.
     
  3. ZBChrist

    ZBChrist Member

    Messages:
    146
    Likes Received:
    0
    alright, after all this I think my vaporizor is broken. I tried it a couple more times and it refused to heat up for a long time. Eventuallly it started to heat up, but could not keep a temperature. I set it for 340 degrees and it jumped all over the place from 200 to 450 degrees until eventually it fried all of the plant matter that was in the tray.

    I am sending it back and getting a replacement... wish me luck!
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice