best way? theres hmm how goods your imagination? theres somany ways to make something but.. a homemade what?..lol leaves ya too wide open since could mean anything best way to make a homemade to me meant making a cerimonialpipe with like 6 stones wired ontoit including a blue onyxy standing in front of the bowl, so when u lit it looking down the stem throughthe blue onyx it went from yellow in center & blue edges then reversed blue center yellow edges.. then red center blue edhge & reverse or hell u could turn youyr kitchen table or any lamp into a forced air power bong or well ya can do whatever your imagination lets u do..theres no best way./.especialy since u gave no guidelines best way tomake a chilum? a chalus? pipe? what?
simplest and most effective... paper towel roll/tube and a socket. small slit in the end of the tube, slip in the socket... done.
if u have a metal pipe i think making a bong is the easiest. melt a hole in a gatorade bottle and push the pipe through. if it isnt underwater, then put a bendy straw in the pipe so it goes into the water. melt a carb. ur good to go
Cut a length about five inches long off your hose, melt a hole slightly smaller than the width of the hose into a gatorade/powerade/oasis (anything with thick plastic and wide mouth like those) bottle and jiggle the hose in while the plastic is soft, this will guarantee an airtight piece. Light a cigarette and after smoking it a bit, so the lit tip is pointed, melt a perfect carb in with it. If you don't smoke cigarettes just use a lighter, won't be as uniform a hole though. Personally i always use a metal cone piece (bowl) which you can pick up for about $2-3, but you can make one out of aluminium foil, or cut one out of a drink can (harder to make, but slightly healthier for you than aluminium foil.) Melt your chosen cone piece into the hose-stem and you're good to go. You can melt the mouth piece of the bottle slightly if you like to make it more comfortable a smoke. I've smoked out of a lot of home mades. Can you tell?
dude, take a mechanical pencil, and screw the tube off of the middle, so that its just a tube. then, you can take a socket and tape it to the pen tube. If you dont have a socket, cut a small square off of a soda can, roll it into a cone, and set it into the pen tube. Cut a hole in a bottle, stick the pen tube in, cut a carb, and your set man.
