melting DMT

Discussion in 'DMT' started by kiddudeson, Jul 1, 2008.

  1. kiddudeson

    kiddudeson Member

    Messages:
    4
    Likes Received:
    0
    so i finally sucessfully did the extraction, i used this method with MHRB and it worked http://www.dmtdrug.com/dmtextraction.htm. i did the ammonia wash at the end and it settled down in the filter and started to dry, i wanted to share with some friends so i left it in the coffee filter to dry and i had the coffee filter pushed down into a mason jar with the edges over the side so it was basically a funnel without a hole. i capped the jar because i was transporting it, i put it in my car and to my friends house i went, i had to stop at my job for about 10 minutes, so i did. total time from my house to my job to my friends house was about an hour, it was hot and the stuff was in my car, when i got to my friends house and uncapped it was gone and the filter where the stuff was sitting was hard , what i am asking is if you think it might have melted from the heat, because it was about 95 deg. farenheight out and i have a black car, black leather and no A/C. And another question is how do i store it, jar, bag, ect. and should i keep it in the fridge, any info for a Newbie would be appreciated.
     
  2. peacegrow

    peacegrow Member

    Messages:
    686
    Likes Received:
    1
    Melting point is pretty low, so I'm sure that's what happened. http://www.erowid.org/chemicals/dmt/dmt_chemistry.shtml

    If I had some, I'd store it in a glass, air tight container in a cool dry place (like a small mason jar...without the filter.) Some people store it in the freezer. I think it's pretty stable. I've heard it will oxidize if left out for a long time. Make sure it stays cool when transporting. < 90F for sure.

    If you think it melted into the coffee filter or jar, you may be able to soak the filter it in a little warm naptha, remove the filter, and then re-crystallize the naptha in the freezer. Depending on how much it was, it may be worth a try.
     
  3. kiddudeson

    kiddudeson Member

    Messages:
    4
    Likes Received:
    0
    thanks man ill try that
     
  4. 36fuckin5

    36fuckin5 Alchemycologist

    Messages:
    2,008
    Likes Received:
    5
    Yeah, it definitely melted into the filter.

    You're gonna want to heat up about 15-20 ml of naptha per gram of DMT in a hot water bath to just under boiling. I'd cut the filter into small pieces. Soak it in the hot naptha for a few minutes or until you're sure everything has dissolved. Strain it through a coffee filter to get all the filter particulate matter out, then throw it in the freezer for at least 6 hours. I do it overnight. In the morning, swish the cold naptha around to knock everything off the sides of the jar and run it through a coffee filter. This should leave you with some nice, pretty, white crystals. If it looks all fucked up and yellow, do it again using a little less naptha.

    I usually store mine in a safe. It stays fairly cool in there. You should find some kind of glass container to keep it in.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice