hey im desperately tryin to make a bong and was wonderin how u could put a hole in glass im sick of plastic bottles how would u put a hole in like a snapple bottle er sumthin
Uh, good luck with that. I'm pretty sure that's not possible...? Sick of crappy plastic bongs? Perhaps its time to invest in a REAL glass bong, or an acrylic even.
i have used a dremel w/ a dimond bit. you still have to be very carefull. i recomend practicing on some junk bottles first.
your better off just buying a bong my friend tryed to make a bong with a torch the bottle blow up in his lap lucky for us the hot glass didnt hit him or me and a week later he tryed useing a drill which ended braking again
my friend made an insence holder out of a glass bottle by drilling a hole in it with a drill. just a handheld one worked for him. just make sure you're careful
Yep, Ive spent many a hours trying to drill holes in stolen Chem lab beakers. Never worked, and I tried everything. It makes so much more sense to either roll, buy a hookah in town, or get a nice plastic or acrylic bong off the net. theo
lol dude plastic bottles are so much better for homemades: wont break when dropped, is incredibly light comparitively, and plentiful (may as well recycle plastic as much as possible)
You make an "X" out of two pieces of electrical tape over where you want to drill the hole. then using a drill, you drill slowly and methodically. I've done this before with good results. An easier way is to get a blowtorch and then just heat up the place you want a hole and then push in the melted glass with a pen or something.
^^ Very fuckin cool. How did you drill the hole? I have a bottle here, that once I finishe the liquor in it, will make a nice bong, but have no idea how to put a hole in it.
ya me and 2 buddys spent like, 1 hour to 2 hours trying to drill a whole threw a glass bottle. we eventually made it..Wasnt too bad of a hole since we used a regular drill bit.
