I need help with my Homemade Bong!!

Hi everyone,
i am new to this website and i need your help.
i recently made a homemade bong out of glass bottles. It is a triple bubbler type bong. I drilled a hole in the largest bottle and holes in the caps of the other two, i am using flexible plastic tubing to go from bottle to bottle. I tried to seal the holes in the caps where the tubing goes in with electrical tape. and i have used a bowl from a bong. for some reason when i smoke out of it, the flow is not very good. Any suggestions on sealing the holes? because i think that might be the problem

Thanks

 

hot glue gun and hot glue

 

Epoxy?

 

do you think the hot glue may melt because of heat from the lighter or no, and will the epoxy give off fumes that may not be so healthy to inhale?

 

Well I've never used epoxy myself but my friend has fixed many a bowl with it. And you're using it to fill in spaces where the tube meets the glass right? I don't think enough heat will come in contact with it make it give off dangerous fumes

 

^^^I agree

 

Epoxy putty I think would work better than epoxy glue. I'm a big fan of the stuff. It is right up there on my list with duct tape & bailing wire.

 

thanks i plan on getting a good smoke thanks to you all

 

rubber cement

 

thanks for the suggestions... ill be sure to post pics of my final product

 

a real bong?

 

its a home made bong made from glass bottles